Toilet Repair

If evacuating the tank note that never ends to fill and / or stop the mechanism (there is a constant noise like water loss) is that the mechanism fails. It may be that the float is not doing the job of cutting the water inlet pressure that is missing or that the valve does not work. In this case we have to change the fill valve and unloader.

Repairing a toilet that leaks water is relatively simple and if you want to save the cost of a plumber, you can do yourself. The tools necessary to fix a water are pliers and wrench.

Change fill valve and unloader of the tank :
Available on the market a wide variety of mechanisms or drain how to replace practically the same for everyone. To fix the problem of water, so just follow these steps:
Off the water and separate the hose:
Close the tap water is usually near the water tank water. With a wrench to loosen the nut that is attached to the tank and unscrew to remove the hose. Place a cap to the hose to prevent water loss.

Remove the lid of the tank :
Remove the shock cap is tightened every time we want to empty the tank having a top notice of termination, remove it. Pick up and raising the handle, hold the rod with pliers by turning slightly and separate drain button, then unscrew the end piece attached to the top of the water. Finally remove the lid of the tank to work within.

Empty the tank :
Discharge lift rod to empty the tank. With wrench remove the nut holding the fill valve (located on the outside of the tank, right where I remove the jumper) and remove the valve and replace the onion. Find an internal board is also important to rule.

Change the downloader :
The arrester is placed a screw, unscrew to remove. Disinfect with a product to flush toilets. Place the drain back to the rod that is used as a drainage mechanism. You have to pass through the hole that has at its end the drain, bottom-up and secure its position. Place the gasket and screw
unloader. 

Change the fill valve with float:
To place the fill valve, first place the inner seal on the end of the valve and enter through the side hole of the tank, insert the seal and the outer nut and turn the wrench until brown and firm.

Final details:
Place the lid of the tank of water by aligning the hole with the rod. Take the handle and place the completion accessories. Finish by placing the hose in place and open the tap water.